Troubleshooting
Picture quality problems
Status
Picture is not clear
Picture is too dark
Picture is too light
58
Possible Solutions
■
To automatically set exposure and focus, press the Shutter button
halfway. When the Ready light turns green, press the Shutter
button completely down to take the picture.
■
Clean the lens
(page
■
Make sure the camera is not in Close-up mode if you are more than
27.6 in. (70 cm) from your subject.
■
Place the camera on a flat, steady surface or use a tripod (especially
in high-zoom settings or in low light).
■
Reposition the camera for more available light.
■
Use Fill flash
(page
the subject.
■
Move so that the distance between you and the subject is within the
effective flash range
■
To automatically set exposure and focus, press the Shutter button
halfway. When the Ready light turns green, press the Shutter
button completely down to take the picture.
■
Reposition the camera to reduce the amount of available light.
■
Turn the flash off
■
Move so that the distance between you and the subject is within the
effective flash range
■
To automatically set exposure and focus, press the Shutter button
halfway. When the Ready light turns green, press the Shutter
button completely down to take the picture.
■
In Auto and Scene-Custom modes, adjust the Exposure
Compensation
(page
69).
9) or change your position so light is not behind
(page
63).
(page
9).
(page
63).
35).
www.kodak.com/go/support