Dodge Dakota 2010 User Manual page 31

• Place the hand-held transmitter 1 to 3 in (3 to 8 cm) from the HomeLink
while keeping the indicator light in view.
• Simultaneously, press and hold both the chosen HomeLink
hand-held transmitter button until the HomeLink
slow to a rapidly blinking light, then release both the HomeLink
transmitter buttons. This may take up to 30 seconds, or longer in rare cases.
• Press and hold the just-trained HomeLink
constantly, programming is complete and the garage door should open.
• Your motorized door or gate will open and close while you are training the universal
transceiver. Do not train the transceiver if people or pets are in the path of the door
or gate. Only use this transceiver with a garage door opener that has a "stop and
reverse" feature as required by Federal safety standards. This includes most garage
door opener models manufactured after 1982. Do not use a garage door opener
without these safety features. Call toll-free 1–800–355–3515 or, on the Internet, at
www.HomeLink.com for safety information or assistance.
• Vehicle exhaust contains Carbon Monoxide (CO), a dangerous gas. Do not run your
vehicle in the garage while training the transceiver. Exhaust gas can cause serious
injury or death.
NOTE: If you are having difficulty training your HomeLink
was manufactured after 1995, you may have a rolling code. Follow the steps below for
Programming A Rolling Code System.
Programming A Rolling Code System
• At the garage door opener motor (in the garage), locate the "learn" or "training"
button. This can usually be found where the hanging antenna wire is attached to the
garage door opener motor (it is NOT the button normally used to open and close the
door).
• Firmly press and release the "learn" or "training" button. The name and color of the
button may vary by manufacturer. Within 30 seconds, return to the vehicle and press
the programmed HomeLink
time). If the device is plugged in and activates, programming is complete.
• If the device does not activate, press the button a third time (for two seconds) to
complete the training.
®
Using HomeLink
• To operate, simply press and release the programmed HomeLink
trained device will operate.
• Refer to your Owner's Manual on the DVD for further details. If you have any problems
programming HomeLink
or, on the Internet at www.HomeLink.com.
®
button; if the indicator light stays on
WARNING!
®
button twice (holding the button for two seconds each
®
, or require assistance, please call toll-free 1–800–355–3515
29
ELECTRONICS
®
button and the
®
indicator flash rate changes from a
®
and the hand-held
®
and your garage door opener
®
button and the
®
buttons