System Connector - Yamaha A-S2100 Owner's Manual

®
AUTO POWER STANDBY switch
ON: The unit enters STANDBY mode automatically
if not operated for 8 hours.
OFF: The unit does not enter STANDBY mode
automatically.
@ TRIGGER IN jack
Use this jack to connect an external component for the
trigger function.
For details on the connection, see page 22.
@ REMOTE IN/OUT jacks
Use these jacks to connect an external component for
remote control.
For details on the connection, see page 21.
@ SYSTEM CONNECTOR
Use this connector to connect a product testing device
for servicing.
@ AC IN inlet
Use this inlet to plug in the supplied power cable.
For details on the connection, see page 19.
@Foot
The feet of this unit include built-in spikes. Using the
spikes can reduce the effect of vibrations on the set.
When using the spikes, remove the transport tape, then
remove the magnet foot by pulling it.
Transport
- - - ¥ \
tape
Caution
¢~··;~
~Magnet
foot
• Take care that the magnet foot is not accidentally
swallowed by small children.
• When using the feet's built-in spikes, the spikes may
scratch
the shelf or floor on which this unit is installed. Use
the magnet feet or appropriate supports when placing this
unit on expensive furniture, etc.
,,,
:<t>~
If this unit is unstable, you can adjust the foot height by
rotating it.
11
En
I