Kodak EASYSHARE DX4900 User Manual page 75

Camera
Problem
Stored pictures are
damaged.
Pictures remaining
number does not
decrease after
taking a picture.
Picture is not clear. The lens is dirty.
Slide show does
not run on external
video device.
Chapter 9
Cause
The card was removed
when the card access
light was blinking.
Picture does not take up
sufficient space to
decrease the picture
remaining number.
Subject too close when
taking picture.
Subject or the camera
moved while the picture
was taken.
The subject is too far
away for the flash to be
effective.
Video Out setting is
incorrect.
External device is set
incorrectly.
Solution
Make sure the card access
light is not blinking before
removing the card.
The camera is operating
normally. Continue taking
pictures.
Clean the lens (page
Move so there is at least 1.6
ft (0.5 m) between the
camera and the subject. Or
use the Close-Up setting
(page 17).
Hold the camera steady
while taking the picture.
Move so there is no more
than 7.5 ft (2.3 m) between
the camera and the subject.
Adjust the camera Video Out
setting (NTSC or PAL,
page 46).
Refer to the external device
user's guide.
80).
65