Kodak EASYSHARE DX4900 User Manual page 74

Camera
Problem
Picture is too dark. Flash is not on or did not
Camera does not
turn on.
Camera freezes up
when a card is
inserted or
removed.
Picture is too light. The flash is not needed. Change to Auto flash or turn
64
Chapter 9
Cause
function.
The subject is too far
away for the flash to have
an effect.
The subject is in front of
a bright light (backlit).
Battery is not properly
installed.
Battery is not charged.
Camera detects an error
when the card was
inserted or removed.
The subject is too close
when the flash was used.
The light sensor is
covered.
Solution
Turn on the flash
Move closer to your subject:
no farther than 7.5 ft (2.3
m) in Telephoto, no farther
than 10.5 ft (3.2 m) in Wide
Angle.
Change your position so the
light is not behind the
subject.
Remove and reinstall the
batteries (page 3).
Replace or recharge the
batteries (page 3).
Turn the camera off, then
back on. Make sure the
camera is turned off before
inserting or removing a
card.
flash off (page 19).
Move so there is at least
1.6 ft (0.5 m) between the
camera and the subject.
Hold the camera so your
hands or other objects do
not cover the light sensor.
(page 19).