Replacing Oven Light Bulb; Line Filter - Amana UCRC518T2 Service Manual

Disassembly Procedures
!

Replacing Oven Light Bulb

!
To avoid electrical shock which can cause severe
personal injury or death, unplug power cord or open
circuit breaker to oven before replacing light bulb.
After replacing light bulb, restore power.
!
To avoid personal injury or property
damage, observe the following:
• Allow oven and light bulb to cool.
• Wear gloves when replacing light bulb.
Tools Needed
• Protective gloves
• Phillips screwdriver
• 25-watt, 230-volt appliance bulb (available from
authorized distributor or servicer)
1. Remove screw from access cover on back panel of
oven exterior. Slide access bracket out.
2. Remove old bulb and replace with new bulb.
3. Replace access cover and screw by reversing
procedure in step 1.
WARNING
WARNING
CAUTION
To remove bulb,
turn in direction
shown.
To avoid the risk of electrical shock, personal injury, or
death, disconnect power to oven and discharge capacitors
before following any disassembly procedure.

Line Filter

1. Unplug power cord from power source.
2. Remove outer case and back panel.
3. Remove screws securing exhaust duct cavity to gain
access to line filter.
4. Disconnect wires attached to line filter.
5. Remove rivets securing line filter to duct cavity.
6. Reassemble in reverse order.
Line Filter
31 RS5320010 Rev. 0