Cook Condition (Dial Models) - Amana UCRC518T2 Service Manual

Troubleshooting–Dial Models(D)
Cook Condition
Place liter of water in
oven and close oven door.
Display
Rotate dial clockwise for
10 second cook cycle.
Yes
Display
:
Yes
Press START pad
pad beeps when pushed?
Display
Yes
:
Display starts counting down.
Open oven door, water is properly heated?
Yes
Oven is operating properly.
NOTE: Shut down after cook cycle - door closed - 30 seconds.
Shut down, door open - approximately 5 minutes.
After shut down, display goes blank.
1. Inoperative touch panel assembly.
NO
2. Broken or improper wire connections.
1. Inoperative touch panel assembly.
NO
2. Broken or improper wire connections.
3. Pad beeper volume set to "OFF".
Heats very slowly.
NOTE: Verify by performing power test.
1. One inoperative diode.
2. One inoperative capacitor.
3. One inoperative magnetron.
4.
Inoperative or misadjusted interlock switch assembly.
Broken or improper wire connection.
5.
NO
No heat.
1. Inoperative triac.
2. Inoperative diodes.
3.
Inoperative capacitors.
4. Inoperative high voltage transformer.
5. Inoperative control board.
6.
Inoperative or misadjusted interlock switch assembly.
7. Broken or improper wire connections.
25 RS5320010 Rev. 1