Download Print this page

Beko BKS 9218 User Manual page 4

Vacuum cleaner with water filtration
Hide thumbs Also See for BKS 9218:

Advertisement

Using your machine
Operating the appliance
After checking if the voltage meets the
rated voltage, plug in the appliance.
Press on/off switch (2) located on the
top of the appliance.
If the water becomes very dirty during
cleaning, replace it as described in the
"Maintenance and Cleaning the
Appliance" section.
Blower Function
Remove the blower cover lid and insert
the hose into the opening on the body.
CAUTION : This appliance is not a
wet&dry vacuum cleaner, but a dry
vacuum cleaner with water filtration.
Avoid sucking any type of liquid with
this vacuum cleaner.
(Figure 15)
5
(Figure 16)
(Figure 17)
4
Maintenance and Cleaning
To empty the water inside the container,
If the vacuum cleaner overturns
switch off the appliance by pushing on
accidentally during operation, switch
the On/Off switch and disconnect the
the unit off and unplug immediately.
power supply cable from the mains.
Dump the water inside the container
Remove the motor unit after unlocking
and follow the cleaning procedure
the container locking/unlocking parts
described in "Maintenance and
on each side of the container.
Cleaning the Appliance" section, above.
Remove the water separator and the
Make sure that all the parts have been
air distributing part.
dried before using the appliance again.
Empty the water inside the container
by tilting it towards the opposite side
of the inlet socket. You can use the
handle of the container.
It is strongly recommended to dump
the water inside the container and to
wash out any dirt that might be
remaining inside the container after
each use.
It is recommended to wipe inside the
container with a dry cloth after washed.
You may wash the HEPA filter under
the water.
It is recommended that the vacuum
cleaner is stored without water inside
the container. It is best to fill the filtration
water (1,5 l) right before the use.
Warnings
Please make sure that the air
distributing part and water separator
parts are always in place when the
vacuum cleaner is operated.
6
(Figure 1)
(Figure 2)
(Figure 3)
(Figure 4)

Advertisement

loading