7 Troubleshooting
This chapter should help you resolve any problems you may encounter
with your DC40 camera. If you cannot resolve a problem after reading
through this information, refer to the "Getting Help" section at the end of
this chapter.
Problems and Solutions
Display Does Not Appear
The camera is not on.
The camera is asleep.
The batteries are low,
dead, or not installed.
The batteries are not
installed correctly.
The power adapter was
disconnected from the
camera while the camera
was still turned on.
36
Cause
Solution
Open the lens cover.
Press the shutter button or the
Feature or Select button
Replace the batteries or use a
power adapter.
Reinstall the batteries following the
instructions in Chapter 1.
Plug the power adapter back in to the
camera, turn the camera on and then
off again, and then disconnect the
power adapter from it.
January 1996