Page 1
System tested and certified by the Water Quality Association against CSA B483.1. Système évalué et certifié par Water Quality Association selon la norme CSA B483.1. Kenmore Model / Modèle 625.75116 Water Softener ® with High Flow Valve Adoucisseur d’eau avec soupape à haut débit Sears Canada Inc.
ONE YEAR LIMITED WARRANTY ON WATER SOFTENER When installed, operated and maintained according to all instructions supplied with the product, if this Kenmore appliance fails due to a defect in material and workmanship within one year from the date of pur- chase, call 1-800-4-MY-HOME to arrange for free repair.
Equipment (WEEE) requirements. This directive or similar laws are in place nationally and can vary from region to region. Please refer to your state and local laws for proper disposal of this equipment. Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com...
Variable Salt Dose: The salt dose is selected by the electronic controls at regeneration time based on the amount needed. PERFORMANCE CLAIMS Maximum Allowable Contaminant Influent Challenge Level Product Water Level Barium 10 ±10% mg/L 2.0 mg/L Radium 226/228 25 pCi/L 5 pCi/L Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com...
8.6 cm 50.2 cm 3-3/8" 19-3/4" IN - OUT IN - OUT 116.8 cm 46" 105.4 cm 102.2 cm 41-1/2" 40-1/4" Figure 1 FRONT VIEW SIDE VIEW FRONT VIEW SIDE VIEW Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com...
Always locate an Iron Filter UPSTREAM of the water softener. Locate a Central Water Filtration System UPSTREAM of the water softener on a chlorinated water supply, or DOWNSTREAM of the water softener on a non-chlorinated water supply. Figure 3 Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com...
Page 7
4. Keep outside faucets on hard water to save soft ments, direct sunlight, contamination, vandalism, etc. water and salt. See Fig. 4. Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com...
NOTE: If you will not install the included Valve Inlet Single bypass valve because you will have Bypass Valve a 3-valve bypass in your plumbing, Clip skip step 6, but perform step 7. Figure 6 Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com...
Page 9
Figure 8 bypass or adaptor Clip ALTERNATE BYPASS VALVE INSTALLATION Figure 10 If connecting to floor level plumbing, install the bypass valve turned downward, as shown. Figure 9 Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com...
Page 10
Air Gap place NOTE: Drain Hose 4 cm (3.6 meters) Air Gap is included. See also parts list. Salt Tank FLOOR DRAIN LAUNDRY TUB Overflow Hose Figure 11 Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com...
Page 11
This normally occurs the first time water runs through the resin bed. The discol- ored water is not harmful, and the discoloration will not last more than a few minutes. Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com...
Page 12
RESTART THE WATER HEATER Turn on the gas (or electric) supply to the water heater and light the pilot. YOUR PLUMBING INSTALLATION AND ELECTRICAL WORK ARE NOW COMPLETE. Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com...
2. When the correct time is displayed, press the SELECT to show the “Set Recharge Time” screen. button, and the display will change to show the continued on next page “Hardness” screen. Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com...
0, until “SALT LEVEL OFF” shows in the display. 4. When the correct salt level is displayed, press the SELECT button, and the display will return to the nor- mal run (time of day) screen. Figure 21 Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com...
25% to water system that will remove in excess of 90% of the ensure continuous soft water. See table at right. sodium and other drinking water contaminants. Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com...
5. When the correct salt level is displayed, press the SELECT button, and the display will return to the nor- mal run (time of day) screen. Figure 23 Figure 25 Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com...
Page 17
Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com...
4. Is the softener’s power supply plugged into a “live”, grounded wall outlet, and the power cable fastened securely to the controller? Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com...
If your water softener does not work properly, make the following easy checks. Often, you will find what is wrong yourself and you won’t have to call and wait for service. If you do not find anything wrong while making the checks, and your softener still does not work properly, call Kenmore Water Line at 1-800-426-9345. PROBLEM...
Page 20
DOWN button to display the 4. Set the present time, hardness, etc., as described on number of regenerations initiated by this controller pages 13 & 14. since the model code number was entered. Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com...
Page 21
TION once more. WIRING SCHEMATIC Back of Electronic Controller (PWA) Pwr. Position/ Turbine Motor Power Supply 120V AC Valve 28V DC 60 Hz Motor Turbine Position Sensor Switch Figure 37 Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com...
Water Softener Exploded View Kenmore Model No. 625.75116 Valve Assembly See Pages 24 & 25 for parts Rating Decal Location Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com...
Page 23
2 ea. of Key Nos. 14 & 71, 7327584 Repl. Bottom Distributor 1 ea. of Key Nos. 12, 13 & 92 7339939 Owner’s Manual Not illustrated. Not included with water softener. Ù Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com...
Page 24
Valve Assembly Exploded View Wear Strip Seal Cross-Section View Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com...
Page 25
O-Ring, 23.8 x 30.2 mm, pack of 4 6 meters Ù 7123613 Silicone Grease (for O-Rings) Ù 42-34405 Flexible Connectors, 3/4” Ù 42-34407 Flexible Connectors, 1” Ù Not illustrated. Not included with water softener. Ù Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com...
Page 26
Get it fixed, at your home or ours! Your Home For troubleshooting, product manuals and expert advice: www.managemylife.com For repair – in your home – of all major brand appliances, lawn and garden equipment, or heating and cooling systems, no matter who made it, no matter who sold it! For the replacement parts, accessories and owner’s manuals that you need to do-it-yourself.
Need help?
Do you have a question about the 625.75116 and is the answer not in the manual?
Questions and answers