Rigging with the MASS™ System
Single Axis
1.
2.
3.
4.
5.
Section 6.6
1. Attach the Protractor Disc to
the Multi Purpose Platewith
attached lever pins. ( x2 )
Attach the Multi Purpose
Plates to the M15 as on p.11
2-4. Slide the U-bar into the
Protractor Disc, and insert the
quick release push-pins on both
sides.
5. (Attach C-Clamp to the U-bar. If
rigging as Dual Axis continue
through steps 7-12.)
7. Screw the U-Disc on to the
U-bar.
8. (Place the Spacer Disc on top
of the U-Disc, the Spacer Disc is
usually permanently attached
to the L-Disc.)
9-11. Place the L-Disc on the
U-Disc, insert the
Machine Bolt and fasten it
from underneath. Then attach the leaver
screws on the top side.
12. Attach
C-Clamp
to the U-bar
and Inspect
attachments
to be certain
they are
secure.
12.
Dual Axis
6.
7.
8.
9.
10.
11.
M15 User Manual Page 20 of 24