Log Placement; Logo Placement - Napoleon GDS20N Installation And Operating Instructions Manual

26
5.3

LOG PLACEMENT

EN
FAILURE TO POSITION THE LOGS IN ACCORDANCE WITH THESE DIAGRAMS OR FAILURE TO USE
ONLY LOGS SPECIFICALLY APPROVED WITH THIS APPLIANCE MAY RESULT IN PROPERTY
LOGS MUST BE PLACED IN THEIR EXACT LOCATION IN THE APPLIANCE. DO NOT MODIFY THE
PROPER LOG POSITIONS, SINCE APPLIANCE MAY NOT FUNCTION PROPERLY AND DELAYED
It is not necessary to remove the cast front, however,
this will make for a more simple log installation.
In order to assemble the log set, the door must
be removed, see "GLASS DOOR / CAST FRONT
INSTALLATION REMOVAL" section in the Finishing
section of this manual.
Place the rear log, as
A.
shown, onto the rear log
support brackets. Ensure
the cutout on the left
underside of the log, fi ts
over the pilot assembly.
Bend the bracket on the
right side to help retain the
rear log.
5.4

LOGO PLACEMENT

Remove the backing from the logo and position onto
the control door as shown.
W415-0496 / H / 07.16.13
DAMAGE OR PERSONAL INJURY.
IGNITION MAY OCCUR.
THE LOGS ARE FRAGILE AND SHOULD BE HANDLED WITH CARE.
BRACKET
B.
WARNING
!
LOG LOCATING SCREWS
Place the hole in the
underside of log #2 onto the
locating screw, on the left
side of the burner. The fi bre
burner is formed to cradle
the centre of the log.
1.27cm
76.1A
Place the hole in the
C.
underside of log #3 onto
the locating screw, on the
right side of the burner. The
bottom branch of log #3 sits
in front of, and against, the
right end of log #2.
Reinstall the glass door &
D.
front.
1.27cm
LOGO