Remote Control; Source Lock; Edgemask; Brightness - Optoma Projector User Manual

User Controls
Lamp
18

Remote Control

Using the Remote Control

Power On
Power Off

Lamp Mode

Mode

4:3
16:9

LBX

Native

Brightness

Contrast

EdgeMask

Source
Lock
Overscan
Refer to the "Power On" section on page 13.
Refer to the "Power On/Off the Projector"
section on page 14.
Increase the brightness of the image. (refer
to page 33)
Select the display mode from Cinema,
Bright, Photo, Reference and User.
Scale the image at a 4:3 aspect ratio.
Scale the image at a 16:9 aspect ratio.
Enable the viewing of the letterboxed
nonanamorphically enhanced movie at full
screen width. Part of the original image will
be lost if the image aspect ratio is less than
2.35:1.
The input source will be displayed without
scaling.
Adjust the brightness of the image.
Control the degree of difference between the
lightest and darkest parts of the picture.
Mask off a few pixels on each edge of the
image to be displayed. Use this function
to adjust if image source happens to have
noise near any edge of the display image.
Select auto detection all connector ports or
lock current connector port.
Mask off a few pixels on each edge of the
image to be displayed. Use the function
to adjust if image source happens to have
noise near any edge of the display image.