Reset The Baby Monitor; Optimize The Battery Life Of The Parent Unit; Guarantee And Service - Philips AVENT SCD505 User Manual

2
To disable ECO mode, press and hold
for two seconds.
» The ECO mode indicator goes out
and the parent unit reboots.

Reset the baby monitor

To reset the parent unit:
1
Press and hold
unit.
2
Press and hold
3
When you hold
» The parent unit is reset.
To reset the baby unit:
1
Follow the same procedure as you reset
the parent unit.
Optimize the battery life of
the parent unit
• Recharge the parent unit when you see
the low battery icon or hear the low
battery alert tone. Fully recharge the
parent unit before you use it again, as
completely draining the rechargeable
batteries may reduce their life.
• Remove the rechargeable batteries from
the parent unit if you are not going to use
it for a week or longer.
• Always fully recharge the parent unit after
a long period of disuse.
• Remove the parent unit from the charging
dock after it is fully charged.
• If you experience any issue with the
rechargeable batteries of your parent unit,
you may contact your dealer or a Philips
service centre.
EN
12
to turn off the parent
on the parent unit.
, turn on the parent unit.
6 Guarantee and
service
If you need service or information or if you
have a problem, please visit the Philips AVENT
website at www.philips.com/AVENT
welcome or contact the Philips Consumer Care
Centre in your country. You can find the phone
number of the Philips Consumer Care Centre
in the worldwide guarantee leaflet. If there is no
Philips Consumer Care Centre in your country,
please visit the local Philips dealer.