AT&T U-verse Quick Fix Manual page 3

How to program your remote to control up to four devices.
3
During installation, the AT&T button was set up to control your AT&T
U-verse® HD-ready receiver. you can also control a TV plus up to two other
devices such as a DVD player, stereo receiver, or home theater in a box by
programming the TV, DVD, and AUX mode buttons. once the devices are
programmed, you simply press the corresponding mode key on the remote
to control that device. To watch a video on how to program your remote,
visit att.com/uverseremote.
NoTE: The instructions below don't require you to enter a manufacturer's device
code because most codes are stored in the AT&T U-verse remote's memory. if you're
unable to add a device, or want to learn about advanced features like reassigning
mode buttons, refer to the remote's manual provided at installation. For more info,
visit support.att.com/userguides.
How to assign devices to TV-DVD-AUX mode buttons:
1. Turn on the device you want to program.
2. Choose a mode button (TV, DVD, or AUX) on your remote that will be assigned to the device. Aim your
remote at the device while pressing and holding that mode button. press oK, then release both buttons.
3. After all mode buttons flash twice indicating your remote is ready to program, enter 9 2 2 on the number
keypad. The previously selected mode button will flash twice.
> you have 10 seconds to enter this programming code (9 2 2) or all the mode buttons will flash once,
indicating that the remote control has exited programming mode. if this happens, just start over.
4. if you're assigning the device to the TV or DVD mode button, press and release PLAY. press ff repeatedly
until the device turns off.
if you're setting up the AUX button, press PLAY, then press 1 for VCr, 2 for stereo receiver/tuner, 3 for
amplifier, or 4 for home theater in a box. AUX will flash twice, indicating correct entry. press ff repeatedly
until the device turns off.
5. press ENTEr to save the settings.
6. The TV, DVD, or AUX mode button you programmed will flash three times to indicate that the programming
has successfully completed.
7. To test it, press the TV, DVD, or AUX mode button you assigned to the device, then press the PoWEr
button to turn the device on and off.
Want more help?
your remote, visit support.att.com/userguides. you can also check the remote's user manual provided at installation,
or watch Help on Demand on TV: press MENU, select Help, then Help on Demand to see all program titles.
3
if you're unable to add a device or want to learn about controlling volume on all devices using
Quick Fix Guide
TV
DVD
AUX
AT&T
MENU
OK
INFO
TV
C
A
B
+
+
GUIDE
CH
VOL
PG
–
–
MUTE
LAST
1 2 3
ABC DEF
6
4 5
GHI JKL MNO
7
8 9
TUV WXYZ
PQRS
0
ENTER
DELETE SPACE ZOOM