Manhattan 525541 User Manual page 103

Remote IP
Address: (e):
Remote Port
Range (f):
Traffic Type (g):
Protocol (h):
After you finish with all settings, click Save (i). You'll be brought
back to the previous menu, and the rule you just set will appear in
the current QoS table. If any settings were incorrect, you'll get an
error message when you click Save: Correct your input per the
instructions given by the error message.
If you decide to erase all values you just entered, click Reset.
Specify the remote (destination) IP address
that will be affected by this rule. Input the
starting IP address in the left field and input the
end IP address in the right field to define a
range of IP addresses, or just input the IP
address in the left field to define a single IP
address.
Input the range of remote (destination) port
numbers that will be affected by this rule. If you
want to apply this rule on Ports 80 to 90, input
"80-90"; to apply this rule on a single port, just
input the port number, like "80." If the remote
(destination) IP address and /or port number is
universal, just leave this blank.
Select the traffic type of this rule: None, SMTP,
HTTP, POP3 and FTP. You can select a
specific traffic type for this rule: If you want to
make this rule an IP address-based rule (apply
the limitation on all traffic to/from the specified
IP address / port number), select None.
Select the protocol type for this rule: TCP or
UDP. If you don't know what protocol your
application uses, try TCP first, and switch to
UDP if this rule doesn't seem to work.
103