Table of Contents
Advertisement
Indicator Lamps and Recorder Status
This table shows the relationship between lamp Lit/Unlit/blinking states and the
recorder's operating status.
: Lit
: Normal blinking
: Blinking consisting of short off intervals combined with long on intervals
Indicator Lamp
REC
READY
(Red)
(Green)
∗1 When there is little space left on a P2 card (about 30 minutes or less) or more
than 1900 recording files (up to 2000 files) have been recorded, the [REC] lamp
will blink continuously.
∗2 If the error is related to the status of the P2 card, the error details will appear in
the status display of the On-Screen. Refer to "Viewing Live Video → Viewing
Memory Card Video Recorder status" in the Operating Instructions of the
Remote Control Panel, or contact your supplier.
Notes:
• If pressing the [REC] button or entering a recording trigger fails to start
recording, the [REC] lamp blinks at a high rate.
• The [BUSY] lamp blinks when accessing the P2 card immediately after
opening or closing the recorder's P2 card slot cover.
48
: Unlit
BUSY
(Red)
Status immediately after power-on
Recorder booting
Live video display
Normal recording
Intermittent recording
• Postrecording
• When uploading or exporting a PC application
Administrator setting screen display with
recording stopped
(not accessing P2 card)
Administrator setting screen display with
recording stopped
(accessing P2 card)
Playing
• Terminating operation
• P2 card start processing (recognition when
inserted)
• P2 card shutdown processing (when a P2
card slot cover is opened)
Updating recorder firmware
Updating microprocessors on the recorder and
Remote Control Panel
An error involving recording operations occurred
,
or
during live screen display
• The recorder's P2 card slot cover is open
• No P2 card is inserted, or it is not recognized
• No more P2 card space available
• The write-protect switch of the P2 card is set
to "PROTECT"
: Fast blinking (about three times/sec)
Recorder Status
∗
1
∗
1
∗
2
Advertisement
Table of Contents
