Table of Contents
Advertisement
5
QQ
3 7 63 1515 0
- How to remove the Pickup unit
1. Remove the pulling spring, torsion spring and E-
shaped ring. Then remove the Clamper arm.
* The spring (A) will be removed with the Clamper
arm.
2. Slide the Clamp UP lever (B) to remove it.
3. Loosen the 2 screws. Remove the feed-screw cover
by sliding it.
4. Remove the feed-screw pressure spring (D).
5. Loosen the 2 screws. Remove the feed-screw holder
(E).
6. Remove the belt.
TE
L 13942296513
8. Loosen the 2 screws. Remove the plate spring and
the rack.
9. Pull out the feed screw from the Pickup unit.
www
.
5
http://www.xiaoyu163.com
6
Carriage
motor
Belt
Feed screw
x
ao
u163
y
i
6
http://www.xiaoyu163.com
7
2 9
8
Pulling spring
Torsion spring
7. Remove the Pickup unit together with the feed screw.
* Be careful not to lose the shaft holders at the both
ends of the feed screw.
* Be careful not to damage the 2 flexible PCBs(for the
Pickup and motor) when separating them. The
flexible PCBs have been stuck each other with
double-sided adhesive tape.
Q Q
3
6 7
1 3
1 5
Pickup
unit
Black
Fig.11
Grease (Yellow:
PG-641)
Feed screw
co
.
Pickup
unit
FX-MG9187ZT/UC
7
9 4
2 8
E-shaped ring
Clamper arm
Fig.10
0 5
8
2 9
9 4
2 8
White
Plate spring
Rack
m
Grease (White: KD-1)
Grease (Yellow:
PG-641)
8
9 9
A
B
C
9 9
D
E
F
Fig.12
75
8
Advertisement
Table of Contents
