Glass Assembly; Grilles And Trim; Hood; Air Shutter Setting - Heatilator GBST36 Series Owner's Manual

G. Glass Assembly
WARNING
Handle glass with care.
• Inspect the gasket to ensure it is
undamaged.
• Inspect the glass for cracks, chips or
scratches.
• Do NOT strike, slam or scratch glass.
• Do NOT operate appliance with glass
assembly removed, cracked, broken or
scratched.
• Replace glass assembly as a complete
assembly.
Removing Glass Assembly
• Remove fi rescreen.
• Pull the four (30/33/36 in. appliances) or seven (42 in.
appliance) glass assembly latches out of the groove on
the glass frame.
• Remove the glass panel from the appliance.
Replacing Glass Assembly
• Set the glass panel on the lower two or four glass assembly
latches, ensuring the glass panel is centered in the
opening.
• Pull out and latch all four or seven glass assembly latches
into the groove on the glass frame.
• Replace fi rescreen.
Top Latches
(hooks)
Glass
Assembly
Glass
Assembly
Latches
(bottom)
Figure 12.2 Glass Assembly
26 Heatilator • Caliber Multi-Sided B-Vent • 4002-094 Rev H • 11/07
H. Grilles and Trim
• Install optional marble and brass trim surround kits using
the installation instructions included with them.
• Marble, brass, brick, tile or other non-combustible
materials can be used to cover the gap between sheet
rock and appliance.
• Do not obstruct or modify the air inlet/outlet grilles.
• Leave space to lower the bottom grille and remove the
trim door.
I. Hood
The hood is to be located above the glass panel. The hood
must be attached or a fi re hazard may result. Locate the four
screws just inside the upper section of the appliance. Posi-
tion the hood and slide into position. Tighten the four screws.
See Figure 12.3.
Figure 12.3 Installing the Hood
J. Air Shutter Setting
Model
GBFL36 Series
GBCR36 Series
GBCL36 Series
GBST36 Series
NG LP
Closed Open