Table of Contents
Advertisement
3-6
Seats and Restraints
3. Pull the pin handle up to
disengage the pin from the
retaining clip, and then pull the
pin out.
4. Repeat this procedure for the
other pins.
5. Pull the seat rearward about
5 cm (2 in), and then lift the seat
from the floor rails.
6. Remove the seat from the
vehicle.
7. For the second- and third-row
seats, stow the safety belt latch
by attaching the clip on the
safety belt latch to the trim just
inside the side door.
For the last row of seats, stow
the safety belt latch plate on the
clip at the window trim.
I n f o r ma t i o n P r o v i d e d b y :
Reinstalling the Rear Seats
WARNING
A seat that is not locked into
place properly can move around
in a collision or sudden stop.
People in the vehicle could be
injured. Be sure to lock the
seat into place properly when
installing it.
WARNING
A safety belt that is improperly
routed, not properly attached,
or twisted will not provide the
protection needed in a crash. The
person wearing the belt could be
seriously injured. After raising the
rear seatback, always check to
be sure that the safety belts are
properly routed and attached, and
are not twisted.
Advertisement
Chapters
Table of Contents
