Hunter HPQ15C-EA Owner's Manual page 6

8. To turn the heater OFF, press the Power Button
unit will first turn off the heating elements, the fan will be shut
down a few minute later. Unplug the unit by pulling the plug from
the electrical outlet only after the fan stopped.
Oscillation
Pressing the Oscillation Button
oscillate back and forth. To stop the oscillation, press the
Oscillation Button
Temperature Control, the oscillation function will stop when the
set temperature is reached and resume when the heater turns
back on.
Timer Function (Figure 3)
The timer function may be activated when the heater display is in
any function. This function allows you to set the length of time
the heater will run before turning itself off, from 1 hour to 8 hours.
Pressing the Timer Button
by 1 hour each time this button is pressed. After the display
reflects 8 hours, pressing the Timer Button
reset the heater to run continuously. The heater will turn off when
the set time has elapsed. The unit can be turned back on by
pressing the Power Button
Automatic Temperature Control (Figure 4) (Figure 5)
The automatic temperature function will only operate on HIGH
heat. You cannot set the temperature automatically when the unit
is in the LOW heat mode.
1. To set the room at a specific temperature, press the
buttons to the desired temperature. The heater is now in Auto
Temperature Mode and the
display.
2. When the display shows the temperature at which you want to
set the unit, the set temperature will flash several times and then
the display will return to indicate the current room temperature
and will gradually change as the room temperature changes.
NOTE: The temperature display does not indicate the
temperature of the heated air being emitted by the heater.
3. Once the room temperature reaches 2 degrees above the set
temperature, the heater will shut off. Once the room temperature
reaches 2 degrees below the set temperature, the heater will
turn back on and continue to cycle off and on to maintain the set
temperature.
will allow the heater to
again. When the heater is in Automatic
will increase the length of time
.
indicator will glow on the LED
. The
once more will
or
6
Figure 3
Figure 4
Figure 5
81602-01 R20140228