Installation - Panasonic WV-SP306 Installation Manual

Installation

Connect the safety wire
The following is an example of safety wire connection.
Important:
• Be sure to install the safety wire. Ask your dealer for installation.
For mounting on ceiling
z
Remove the tripod mount base on the top of
the camera.
x
Align the tripod mount base with the safety wire
plate for ceiling (accessory) and attach them to
the camera with the mounting screws.
Important:
• Use the detached mounting screws to attach the tripod mount base. When using different
length screws, it may damage the camera or cause the camera to fall.
(Recommended tightening torque: 0.39 N·m {0.29 lbf·ft})
c
Engage the safety wires (2 pieces) with the wire engaging holes (front and rear) respectively.
Wire engaging hole
q Pass the ring part of the safety wire
through the wire engaging hole.
Safety wire
Mounting screws
Tripod mount
base
Safety wire plate
for ceiling
(accessory)
Wire engaging
hole (front)
w Pass the other end of the safety wire
through the ring part of the safety wire.
Wire engaging
hole (rear)
21