Installation And Setup - AT&T E6012B Quick Start Manual

Installation and setup

Choose a central location close to a telephone jack and a power outlet not
connected to a wall switch. The telephone base can be placed on a flat sur-
face or mounted on a standard wall plate. For optimum range and better
reception, place the telephone base in a high and open location.
Avoid placing the telephone base too close to:
• Communication devices such as: personal computers, computer routers, tel-
evision sets, VCRs, wireless routers (wireless broadband, wi-fi, or 802.11) or
other cordless telephones.
• Excessive heat sources.
• Noise sources such as a window with traffic outside, motors, microwave
ovens, refrigerators, or fluorescent lighting.
• Excessive dust sources such as a workshop or garage.
• Excessive moisture.
• Extremely low temperature.
• Mechanical vibration or shock such as on top of the washing machine or
work bench.
1.
Plug one end of the telephone line
cord into the telephone jack at the
bottom of the telephone base.
5.
Plug the other end
of the telephone line
cord into a telephone
jack.
DSL filter
(Optional for DSL users, see number
four in the NOTES section, below.)
NOTES:
1. The mounting bracket must be used for both tabletop use and wall mounting positions.
2. Use only the power cord supplied with this product, if you need a replacement, visit our web-
site at www.telephones.att.com or call 1 (800) 222-3111. In Canada dial 1 (866) 288-4268.
3. Be sure to use an electrical outlet not controlled by a wall switch.
4. This power adapter is intended to be plugged into a vertical wall outlet or a floor outlet. The
prongs are not designed to hold the plug in place if it is plugged into a ceiling, under-the-
table or cabinet outlet.
5. If you receive high speed internet through your telephone line (commonly referred to as DSL),
and you are experiencing interference during telephone conversations and/or your caller ID
features are not functioning properly, install a DSL filter to the telephone line between the tel-
ephone base and the telephone wall jack. Contact your DSL service provider for a DSL filter.
Telephone line cord
2.
Plug the small end of the larger power adapter
into the power jack at the bottom of the telephone
base.
3.
4.
Plug the large end of the larger power
adapter into an electrical outlet not control-
led by a wall switch.
Route cords through slots.