Silvercrest URC 101 DT Operation And Safety Notes page 54

Press OK (12)
Confirm with OK (12)
Select the source button (2) on which the device of the
original remote control was programmed.
The request
Select a button on the remote control on which the
function of the original remote control should be saved.
(Except the setup (17) and macro (15) buttons.)
Then the screen will show
on the original remote control of which the function is
to be transferred to the universal remote control. Hold
this button down until either the message
The following question will appear:
If you wish to carry out more learning functions then
confirm with OK (12)
appear again on the screen. Carry on as described
above.
If you wish to exit the learning function, press EXIT (16)
.
The remote control will then revert back to normal use.
52
to bring up
appears.
again.
will be shown on the screen.
. The request
.
. Press the button
will
or