Silvercrest URC 101 DT Operation And Safety Notes page 49

The display will show
second command.
In our example: Press the record button (9)
(Y=3).
In our example: Press the record button (9)
After the third command the confirmation message
shown on the display.
In order to use this timer, the time must be set in the
remote control.
You can cancel the programming at any time by pressing
the EXIT button(16)
Deleting command timers
When a command timer is already set up (bell symbol
shown on the display)
display instead of
steps.
will appear after the second command
will appear and the bell symbol will be
.
. (Y=2) Enter the
will appear on the
(X=1,2,3,4) in the above
.
again.
47