Night Security Illumination - Mercedes-Benz C-class Operator's Manual

Instruments
Operation
and controls
Exterior lamp switch
Daytime running lamp mode
Turn exterior lamp switch to position M.
When the engine is running, the low beam headlamps
(includes parking lamps and license plate lamps) are
automatically switched on.
Canada only:
When shifting from a driving position to position "N"
or "P", the low beam switches off (3 minutes delay).
For nighttime driving the exterior lamp switch should
be turned to position B to permit activation of the
high beam headlamps.
USA only:
The high beam headlamps can also be activated when
driving with the daytime running lamp mode activated
and exterior lamp switch in position M.
See page 130 for notes on the exterior lamp switch.
To activate the daytime running lamp mode, see
"Individual settings" – "LIGHTING" on page 117.
Instrument
Driving
cluster display
Practical hints Car care
132

Night security illumination

When turning off the engine, the exterior lamps switch
on for added illumination, if they were previously
switched on (except in daytime running mode). After
the last door has been closed the lamp-on time period
commences.
The lamp-on time period for night security illumination
can be set at several different timed levels from 0 (off) to
60 seconds, see "Individual settings" - "LIGHTING" on
page 117.
Notes:
Within 10 minutes after closing the last door the night
security illumination can be reactivated by opening a
door.
See "Individual settings" – "LIGHTING" on page 117 for
instructions on how to activate the function.
Deactivating night security illumination temporarily:
Turn the electronic key in starter switch to position 0
then to position 2 and back to position 0 again before
getting out of the vehicle. The night security
illumination will not be activated when the door is
opened.
Technical
Index
data