Advertisement
Contents
Connections
B Click the "Advanced" tab.
C Select the sampling rate and bit rate to be applied to the D/A
converter.
It is recommended that "2 channel, 24 bit, 192000 Hz (Studio
0
Quality)" is selected.
D Click "Apply".
E Click "Test".
Check that audio from this unit is output from the PC.
0
Digital Audio Interface Properties
General
Supported Formats
Levels
Default Format
Select the sample rate and bit depth to be used when running
in shared mode.
2 channel, 24 bit, 192000 H
2 channel, 24 bit, 44100 H
2 channel, 24 bit, 48000 H
2 channel, 24 bit, 96000 H
2 channel, 24 bit, 192000 H
Allow applications to take exclusive control of this device
Give exclusive mode applications priority
Restore Defaults
Restore Defaults
Front panel
Side panel
Playback
w
Advanced
t
Studio Quality
Test
Studio Quality
Studio Quality
Studio Quality
e
Studio Quality
r
OK
Cancel
Apply
Apply
Rear panel
Settings
NOTE
0 The dedicated driver must be installed in the PC before this unit is connected to a
PC. Operation will not occur correctly if connected to the PC before the dedicated
driver has been installed.
0 Operation may fail in some PC hardware and software configurations.
29
Index
Tips
Appendix
Advertisement
