Table of Contents
Advertisement
Quick Links
12
SUPASTOR
UNVENTED CYLINDERS
Installation, commissioning
and maintenance instructions
Direct and indirect enamelled cylinders:
120, 150, 180, 210, 250 and 300 litres
A P P R O V E D
U K A S
QUALITY
MANAGEMENT
BS EN ISO 9001
Certificate No: FM 34109
Flamco UK Limited.
Unit 4,
St. Michael's Road,
Lea Green Industrial Estate,
St. Helens
Merseyside WA9 4WZ.
Telephone: 01744 818100.
Important:
Fax: 01744 830400.
Please read these instructions carefully before proceeding
Email: info@flamco.co.uk
with installation. Failure to do so may invalidate warranty.
www.flamco.co.uk
Ref:Inst 5C/03
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for flamco 120 litres
Summary of Contents for flamco 120 litres
- Page 1 A P P R O V E D U K A S QUALITY MANAGEMENT BS EN ISO 9001 Certificate No: FM 34109 Flamco UK Limited. Unit 4, St. Michael’s Road, Lea Green Industrial Estate, St. Helens Merseyside WA9 4WZ. Telephone: 01744 818100.
-
Page 2: Expansion Vessel
Local Authority. Expansion vessel SUPASTOR DIRECT CYLINDER (Diagram A) The Supastor direct cylinder, available in nominal capacities of 120 litres, 150 litres, 180 litres, 210 litres, 250 litres Safety and 300 litres, are supplied as:- group One large box containing - The Supastor unit with factory fitted temperature and pressure relief valve and magnesium anode. - Page 3 Higher temperatures without additional controls If the system is to be fitted with a 3 port valve, the 2 port valve supplied by Flamco must still be fitted. would result in scalding.
- Page 4 TEMPERATURE AND PRESSURE RELIEF VALVE Recommended Direct System The factory fitted temperature and pressure relief valve, sited on top of the unvented cylinder, is a safet device to Economy 7 back-up and support the thermostat(s) and thermal cut-out(s). It operates when either excess pressure or excess temperature is sensed.
- Page 5 The installation should be carried out as follows: Element relief valve Remove the magnesium anode fro the Supastor cylinder, using a 1.1/4” x 3/4” bush insert the Flamco impressed Metal dischage pipe current anode. from tundish with Discharge continuous fall.
- Page 6 FAULT FINDING GUARANTEE Flamco UK Limited guarantee that should this water heater prove to be defective by reason of faulty manufacture during the periods stated below, will replace the defective parts or product free of charge on the condition that:-...
Need help?
Do you have a question about the 120 litres and is the answer not in the manual?
Questions and answers