Starting The Printer - Ice Zodiac Plus Operator's Manual

Starting the Printer

When the printer is switched on, the printer state changes from the
SHUTDOWN to the STARTING UP and then to the OFFLINE state.
Under this condition, all the external electrical inputs are ignored and
the print sensor signals will not trigger a print. This enables you to
check if the line and the printer are ready for production, before you
switch the printer into the RUNNING state to start printing.
To switch the printer to the RUNNING state, touch the Start button
(Figure 3-6).
Figure 3-6: Start Button
Figure 3-7 displays the CLARiTY home page with the printer in the
RUNNING state.
Figure 3-7: CLARiTY Home Page in the Running State
Note: If the printer has a fault or a warning, RUNNING will be replaced
with FAULT or WARNING. If FAULT is displayed, you must fix the
problem before trying to print. Refer "Clearing a Fault Message or Warning"
on page 5-2 for further
Rev AA
Start Button
information.
Zodiac Plus Operator Manual
Starting the Printer 3-5