Attaching The Seatb; Seat Back Attachment; Eat Ovement Ttachment; Seat Bottom Attachment - European Touch Rinato SPA Service Manual

A
TTACHING THE
Please make sure that all parts are removed from the box before discarding the box. If any parts are missing, you
must contact EUROPEAN TOUCH within 30 days of the delivery date for replacement at 800-626-6912.
Your pedicure spa shipped with the seat back already attached to the spa and with the seat bottom cushion in the
spa shipping box. Follow these instructions to connect the seat back and the seat bottom to the pedicure spa:
Note: 2 people are required to perform the following instructions.
Step 1
Step 1 & 2
Step 2
Document ID: 30080002
S B
EAT ACK AND
Steps 2 & 3
Step 3
Rev: C Technical Support: 800-626-6912
S B C
EAT OTTOM
S B A
EAT ACK TTACHMENT
1. Lift seat back vertically and lower hinge
brackets into position.
2. Align seat back bracket hole for pin
insertion.
3. Insert clevis pin from front and push
through aligned holes. Push hitch pin into
the clevis pin as shown.
Note: Repeat steps two and three for other
side.
S M A
EAT OVEMENT
1. Remove the linear drive hitch and clevis
pins located on the seat back mounting
bracket on the back of the chair.
2. Slide the seat bracket, insert attached,
into the black end on the linear actuator
and line up the holes. Slide the clevis
pin through the holes and secure by
inserting the hitch pin through the small
hole on the clevis pin.
Clevis Pin
S B A
EAT OTTOM TTACHMENT
1. The seat bottom cushion will be located
in the spa on top of the spa basin.
Remove the seat bottom cushion from
the spa basin.
2. With the chair fully reclined, attach the
seat bottom cushion to the spa, aligning
the seat bottom
provided Velcro strips. Ensure that the
rear of the seat bottom cushion is tight
against the seat back.
3. Move seat forward and attach bottom
cushion heater connectors as shown.
USHION
TTACHMENT
Hitch Pin
cushion with the
Page 6 of 16