Important Requirements; Specifications Summary; Location And Support - European Touch Rinato SPA Service Manual

I R
MPORTANT EQUIREMENTS
EUROPEAN TOUCH requires that you contact your local, licensed plumber and licensed
electrician to install your new pedicure spa. Installation must be in compliance with all your
local and state building codes. Your pedicure spa cannot operate efficiently or safely unless it
is provided with adequate electrical power, sufficient water pressure, proper water
temperature, and required drainage capabilities. Contact your local building inspector for
information and local code compliance procedures that need to be followed when having your
pedicure spa installed. Subsequent inspections and approvals that may be required are the
responsibility of the purchaser. (See limited warranty regarding incidental or
consequential exclusions – page 2).
S S
PECIFICATIONS UMMARY
Note: Failure to comply with federal, state or local codes and ordinances will result in warranty
being null and void.
WARNING:
Shells & front plate MUST be removed prior to moving the Rinato Spa.
Spa shipping configuration removal Spa appearance prior to moving into place
L S
OCATION AND UPPORT
Select a level location. The floor structure beneath the pedicure spa must be capable of
supporting the occupied pedicure spa. For the seat back to fully recline, the pedicure spa base
must be mounted 17 inches from the wall as shown below:
Document ID: 30080002 Rev: C Technical Support: 800-626-6912 Page 4 of 16