Table of Contents
Advertisement
26
Step 6: Configuring a Multi-EMC System
Addressing Each EMC Through the DIP Switch
The EMC communicates over an RS-485 serial direct connection. The address DIP switch (SW1) is
located at the upper right of the board. Set each EMC DIP switch uniquely in sequential order (from 1 to
32), starting with the first EMC (the one connected to the RS-485 converter at the PC), EMC 1 in Figure
25.
Factory
Setting
Doc 6001536, Rev C
Figure 26: EMC Dip Switches
Advertisement
Table of Contents
