Tools And Materials Needed For Installation; Electrical Requirements; Recommended Grounding Method; Parts Supplied For Undercounter Installation - KitchenAid compactor Installation Instructions Manual

Tools and
materials
needed for
instaIIatSon:
Parts supplied
for undercounter
instaIIat3on:
1 LH retaining bracket
1 RH retaining bracket
2 retaining bracket screws #8 x 5/16
2 mounting clips
2 mounting screws #8 - 18 x 112
All parts are in literature
package in drawer,
Electrical
reauirements
Impo~?an+: Observe all
governing codes and
ordinances.
Electrical Shock Hazard
l
Electrical ground is required
on this appliance.
l
If cold water pipe is
interrupted by plastic, non-
metallic gaskets or other
insulating materials, Do Not
use for grounding.
l
Do Not ground to a gas
pipe.
l
Do Not modify the power
supply cord plug. If it does
not fit the outlet, have a
proper outlet installed by a
qualified electrician.
l
Do Not have a fuse in the
neutral or grounding circuit.
A fuse in the neutral or
grounding circuit could
result in an electrical shock.
l
Do Not use an extension
cord with this appliance.
l
Check with a qualified
electrician if you are in
doubt as to whether the
appliance is properly
grounded.
Failure to follow these
instructions could result in
serious injury or death.
If codes permit and a separate
grounding wire is used, it is
recommended that a qualified
electrician determine that the
grounding path is adequate.
A 120-volt, 60-Hz, AC-only, 1.5 or
20-ampere, fused electrical supply
is required. Time-delay fuse or
circuit breaker is recommended.
It is recommended that a
separate circuit serving only this
appliance be provided
Recommended
groundfng
method
Do Not, under any
circumstances, remove the
power supply cord grounding
prong.
For your personal safety, this
appliance must be grounded.
This appliance is equipped with
a power supply cord having a
3-prong grounding plug. To
minimize possible shock hazard,
the cord must be plugged into
a mating, 3-prong, grounding-
type, wall receptacle,
grounded in accordance with
the National Electrical Code
ANSI/NFPA 70-latest edition and
all local codes and ordinances.
If a mating wall receptacle is
not available, it is the personal
responsibility and obligation of
the customer to have a
properly grounded, 3-prong,
wall receptacle installed by a
qualified electrician. (See
Figure 1 ,I
J-prong
grounding-+ype
wall receptacle
. . ..-. . . . .
. .,
'.. power
supply cord
Figure
1
Page 2