Download  Print this page

Installation Instructions; Unpacking; Location Requirements - KitchenAid Architect Series II W10242569A Use And Care Manual

Integrated compactor
Hide thumbs

Advertisement

Installer: Leave Use and Care Guide with the homeowner.
Homeowner: Keep Use and Care Guide for future reference and for local electrical inspector's use, if required.

Unpacking

WARNING
Excessive Weight Hazard
Use two or more people to move and install compactor.
Failure to do so can result in back or other injury.
IMPORTANT:
Do not grasp console to move compactor.
Begin in the room where the compactor will be located.
1. Remove compactor from shipping carton. Remove all
packaging materials such as tape and shipping pads. Use a
mild detergent and warm water to remove waxy residue
caused by shipping material. Dry thoroughly with a soft cloth.
For more information, see "Cleaning."
2. Be sure the power cord is attached to the cord clip on the
rear of the compactor.
A
A. Cord clip
3. Place the 2 corner posts from the carton on the floor near the
compactor. Open the compactor drawer and remove any
shipping materials or other items from the drawer. Do not
remove the compactor bag. Grasp the handle and raise the
front of drawer until it clears the drawer stops. Grasp sides of
drawer and lift drawer out of compactor. Place the drawer on
the 2 corner posts.

INSTALLATION INSTRUCTIONS

4. Place the other 2 corner posts on the floor to the side of the
compactor. Grasp the sides of the compactor cabinet and put
compactor on its side on top of the corner posts. Remove the
shipping base from the bottom of the compactor.
A
A. Leveling legs
B. Shipping base

Location Requirements

Product Dimensions
34 "
(86.7 cm)
(38.1 cm)
B
24"
15"
(61 cm)
3

Advertisement

Table of Contents
loading

This manual is also suitable for:

Kucs03ftss