Assembly; Packing List; Attaching Injection Hose; Assembling The Trigger Handle - Black Max BM80915 Operator's Manual

UNPACKING
this product requires assembly.
 Carefully cut the box down the sides then remove the
tool and any accessories from the box. Make sure that
all items listed in the packing list are included.
NOTE: this tool is heavy. to avoid back injury, lift with
your legs, not your back, and get help when needed.
WARNING:
this new product has been shipped in a partially as-
sembled condition as described below. Carefully check
the packing list below to ensure all items are included in
the package. the packing list describes all loose items
that are not assembled to the product as shipped. Do not
operate the product if any packing list items are already
assembled to your product when you unpack it. Call the
customer service number below for assistance. opera-
tion of a product that may have been improperly preas-
sembled could result in serious personal injury.
 inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
 if any parts are damaged or missing, please call
1-800-726-5760 for assistance.

PACKING LIST

Pressure Washer
25 ft. High Pressure Hose
trigger Handle
Spray Wand
Quick-connect Nozzles (4)
injection Hose with injection Hose Filter
4-Cycle engine oil (SAe 30 or SAe 10W30)
Handle
operator's Manual
WARNING:
if any parts are damaged or missing do not operate this
tool until the parts are replaced. Failure to heed this warn-
ing could result in serious personal injury.

ASSEMBLy

WARNING:
Do not attempt to modify this tool or create accesso-
ries not recommended for use with this tool. Any such
alteration or modification is misuse and could result in a
hazardous condition leading to possible serious personal
injury.
WARNING:
to prevent accidental starting that could cause serious
personal injury, always disconnect the engine spark plug
wire from the spark plug when assembling parts.
INSTALLING THE HANDLE
See Figure 2.
To install the handle:
 Push and hold the button on the handle as you slide the
handle into the holes in the frame.
NOTE: Before use, pull the handle up until the lock
button snaps through the locking slot to secure the
handle in place.

ATTACHING INJECTION HOSE

See Figure 3.
Before detergent can be used with this machine, the injection
hose must be attached.
 Push the open end of the clear injection hose securely
over the fitting as shown in figure 3.
 Place the filtered end of the injection hose in the bottle
of detergent.

ASSEMBLING THE TRIGGER HANDLE

See Figure 4.
To attach the spray wand:
 Place the threaded end of the spray wand in the connector
on the end of the trigger handle.
 turn the connector clockwise until it stops. this
the spray wand in place.
CONNECTING HIGH PRESSURE HOSE TO
TRIGGER HANDLE
See Figure 5.
 Screw the collar on the high pressure hose into the
trigger handle inlet coupler by turning the hose collar
clockwise.
 Pull on the hose to be certain it is properly secured.
Page 8 — English
secures