Assembly - Black Max BM80930 Operator's Manual

UNPACKING
This product requires assembly.
 Carefully remove the product and any accessories from
the box. Make sure that all items listed in the packing list
are included.
NOTE: This tool is heavy. To avoid back injury, lift with
your legs, not your back, and get help when needed.
WARNING:
Do not use this product if any parts on the Packing List
are already assembled to your product when you unpack
it. Parts on this list are not assembled to the product by
the manufacturer and require customer installation. Use
of a product that may have been improperly assembled
could result in serious personal injury.
 Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
 If any parts are damaged or missing, please call
1-800-726-5760 for assistance.
PACKING LIST
Pressure Washer
30 ft. High Pressure Hose
Trigger Handle
Spray Wand
Quick-connect Nozzles (4)
Detergent Injection Hose with Filter
4-Cycle Engine Lubricant (SAE 30 or SAE 10W30)
Handle
Trigger Handle Holder
Screw
Axle (2)
Hitch pins (2)
Wheels (2)
Washers (2)
Disposable Funnel
Operator's Manual
WARNING:
If any parts are damaged or missing do not operate this
tool until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.

ASSEMBLY

WARNING:
Do not attempt to modify this tool or create accesso-
ries not recommended for use with this tool. Any such
alteration or modification is misuse and could result in a
hazardous condition leading to possible serious personal
injury.
WARNING:
To prevent accidental starting that could cause serious
personal injury, always disconnect the engine spark plug
wire from the spark plug when assembling parts.
INSTALLING THE WHEELS
See Figure 2.
 Locate the axles, hitch pins, washers, and wheels.
 Slide the axle through the hole in the center of the wheel.
 Slide the washer onto the axle.
 Lift the machine and slide the axle into the wheel mount-
ing hole in the machine base as shown.
 Push the hitch pin into the hole on the end of the axle to
secure the wheel assembly.
NOTE: The hitch pin should be pushed into the axle until
the center of the pin rests on top of the axle.
 Repeat with the second wheel.
INSTALLING THE HANDLE
See Figure 3.
CAUTION:
Be careful to avoid pinching your fingers or hands when
installing the handle onto the frame.
 Push and hold the push-pin buttons on the frame as you
slide the handle onto the frame and over the buttons.
 Adjust the handle so that the frame push-pin buttons
snap into holes in the base of the handle.
NOTE: Before use, pull the handle up until the push-pin
buttons snap through the locking holes to secure the
handle in place.
INSTALLING TRIGGER HANDLE HOLDER
See Figure 4.
 Insert trigger handle holder into holes in handle, as shown.
 Thread screw through holder and into handle. Tighten
securely.
Page 7 — English