Banner American Easy-lam II Operating Instructions Manual page 11

(Use a piece of tape to hold film in place). See Figure 5 and 6.
NOTE: The shiny side of the film must always go against the heat shoes.
CAUTION! The heat shoes reach a temperature of up to 350°F. Do not touch
the surface of the heat shoes.
1. Turn the motor switch to the "on" position to start the rollers.
Push a piece of thin letter-sized cardboard against the film so that it is
centered between the two heat shoes. Push the cardboard and film into
the nip rollers. See Figure 5.
Figure 5
Figure 6
11