Banner American Easy-lam II Operating Instructions Manual page 10

1 Pull 6"-12" of film from the top roll. Pass the film under the idler bar and
safety shield, and over the heat shoes. Make sure the shiny side of the film is
against the shoes. See Figure 5 and 6.
2 For the bottom supply roll, remove the feed table. Place the mandrel
ends into position in the lower mandrel holder slots. If you are facing the front
of the laminator, the film should unwind away from you from the bottom of the
rollers as shown in Figure 4.
Figure 4
4. Pull 6"-12" of film from the bottom roll. Pass it under the lower idler bar.
You can "drop-down" the lower idler bar to give you more clearance. After
doing so, return the idler bar to its upper position for running the machine. If the
idler bar is not in the upper position, you will not be able to properly adjust roll
film tension. Drape the film from the bottom roll over the film from the top roll.
10