Table of Contents
Advertisement
There are two methods of selecting which Input channels are assigned to these faders:
-
By pressing the Input Fader Page buttons
faders, the first 3 (A,B,C) are fixed as Channels 1-9, 9-16 and 17-24 respectively, whilst the sec-
ond 3 (USER 1, USER 2, USER 3) default to Channels 25-32, 33-40, 41-48 but can be custom-
ised with the associated Fader Page Setup button.
-
By touching the Input Meter screen
required. This method temporarily takes priority over the setting made using the Input Fader Page
buttons, and the last selected Input Fader page button flashes to indicate that it has been tempo-
rarily replaced by the meter selection.
Accessing Bus Masters on the right-hand Fader Bay
Although all the 32 Bus masters on the console can be accessed using the dedicated Master Section
Faders A, and their corresponding Fader Page buttons B, it is not possible to gain access to the Bus Mode
and Format controls (Grp/Aux/Matrix and Mono/Stereo mode switches) from this area of the console.
When access to these parameters is required, or when easy access to multiple output channel process-
ing sections such as GEQ is required, groups of 8 Bus Masters can be assigned to the right-hand block
of 8 faders by touching the Output Meter screen
required.
This method temporarily takes priority over any current input assignments made by the Input Fader Page
buttons, and will cancel any existing Input channel selection made by touching the Input Meter screen.
Note that the ALL BUSSES button within the Input Fader Page control section
the first 8 Bus Masters to the right-hand fader bay. This function is duplicated by touching the Output
Meter screen for Busses 1-8.
Soundcraft Vi2™ User Guide Supplement 0210 BD10.947003 Rev 0
D
on the left of the fader panel. This gives 6 pages of
E
on the block of 8 meters corresponding to the channels
F
on the block of 8 meters corresponding to the Outputs
D
can also be used to select
Page 7
Advertisement
Table of Contents
