Related Manuals for SoundCraft Vi2
Summary of Contents for SoundCraft Vi2
- Page 1 USER GUIDE SUPPLEMENT Please read in conjunction with the Vi6 User Guide Soundcraft Vi2™ User Guide Supplement 0210 BD10.947003 Rev 0 Page 1...
-
Page 2: Table Of Contents
Connecting the Vi2............................5 Operational Principles..........................6 Accessing Bus Masters on the right hand fader bay...................7 Vi2 Power Supplies.............................8 Compatibility of spares with Vi4/Vi6......................8 Hints on using a UPS..........................8 Soundcraft Vi2 Dimensions........................8 Page 2 Soundcraft Vi2™ User Guide Supplement 0210 BD10.947003 Rev 0... -
Page 3: Introduction To The Soundcraft Vi2
Apart from the smaller number of input faders, operation of the Vi2 is identical to that of the Vi4 or 6. You can also create Show files on a Vi2 and load them into a Vi4 or 6, or vice versa. -
Page 4: Key Features
• Simultaneous operation with another Vi console connected to the same Local Rack will be pos- sible with a future software release, but this feature is not currently available. Page 4 Soundcraft Vi2™ User Guide Supplement 0210 BD10.947003 Rev 0... -
Page 5: Connecting The Vi2
In either case, Vi4/6 Racks have no knowledge of which kind of surface is attached, so there is no spe- cial setup required when an existing Vi4/6 rack is used with a Vi2 Surface – simply connect up as shown below. -
Page 6: Operational Principles
Operational Principles The operation of the Vi2 will be obvious to users familiar with the Vi4 or 6 consoles, the Vi2 is in fact identical to the right-hand two bays of the standard Vi4 or 6 surface, missing only the 2 or 3 Input bays to the left of the master section. -
Page 7: Accessing Bus Masters On The Right Hand Fader Bay
8 Bus Masters to the right-hand fader bay. This function is duplicated by touching the Output Meter screen for Busses 1-8. Soundcraft Vi2™ User Guide Supplement 0210 BD10.947003 Rev 0 Page 7... -
Page 8: Vi2 Power Supplies
For this reason, it is possible in an emergency should both Vi2 power supplies fail, to fit a single spare power supply unit from a Vi4/6. The Vi4/6 unit can be bolted straight in in place of the dual Vi2 unit, as both have the same footprint.