Electric Motors; Engine Protection; Awning - e-motion electric pleasure boat Owner's Instruction Manual

To ensure the safety of ship driver and passengers it is necessary to always put the
emergency cord bracket on the emergency switch, and the other end of the emergency
cord must be securely attached to the wrist of the ship driver or to his lifejacket.
Important:
Before leaving the boat and leave it for storage, be sure that the bracket of
the emergency cord is pulled off the emergency switch and the power supply is
turned off.

5.5 Electric motors

The electric boat is equipped with two noiseless electric motors running synchronously.
The motors are installed on the underwater part of the hull in the transom area.
Important:
Do not start the motors without water. motors should be immersed in the water
to prevent overheating. running engines in a dry mode can severely damage the
engine seals and cause them to break.

5.6 Engine protection

Engines protection frame is designed to protect the housing of the electric motors and
propellers from underwater objects and shoals while driving the boat. Protection is made
of stainless steel and is located in the engine installation area.
The frame does not guarantee absolute protection of engines and propellers. Therefore
it is necessary to make every possible effort to avoid collisions of the electric boat with
any underwater objects and shoals.
Warning:
Do not use the protective frame as a step for boarding! It is dangerous!

5.7 Awning

The electric boat is equipped with awning assembly with arches and a cover. Installa-
tion and removal of awning arcs is simple and convenient due to the use of quick-release
pins and clamps
Important:
With strong gusts of wind it is recommended to fold the awning into the stowed
position. (Fig. 2)
9