Page 2
Dear Owner! We are glad that you have chosen the E.motion electric pleasure boat. This manual will help you to understand the features of operation, care and mainte- nance, and will also help to prevent unexpected problems in the operation.
1. Technical characteristics of E.motion Hull length 3.05 m Hull width 1.75 m Hull height 0.98 m Keel depth at peak load conditions 0.38 m Maximum weight of boat with engines 160 kg Maximum accepted load with 4 batteries 150 kg/2 people + 120 kg/4 batteries = 270 kg Maximum weight with passengers and 430 kg...
3. Configuration of the electric boat The boat is available in the following standard configuration: • boat hull and deck assembly • 2 stationary electric motors with propeller assembly, power - 0.34 kW (0.46 h.p.) • fender guard along perimeter • 2 protection frames for engine and propeller • 2 onboard chargers • emergency power switch...
5. Description and construction The main material used in the construction of the hull is molded fiberglass on the basis of polyester resin. At equipment fixing points there are located reinforcements and em- bedded details. Connection of hull and deck made with stainless steel fasteners. Along the perimeter of the board a fender guard is mounted that protects the boat from dam- age.
In case of an accident, or if a lot of water (more than 35 liters) got into the boat, the automatic pump is switched on and the water is removed from the intrashell space over- board. The pump is equipped with a return valve hindering coming outside water into the boat through the outlet connection.
To ensure the safety of ship driver and passengers it is necessary to always put the emergency cord bracket on the emergency switch, and the other end of the emergency cord must be securely attached to the wrist of the ship driver or to his lifejacket. Important: Before leaving the boat and leave it for storage, be sure that the bracket of the emergency cord is pulled off the emergency switch and the power supply is...
Figure 2 6. Electrical system Electrical components installed by the boat manufacturer are shown in the diagram (Fig. 3). The diagram also contains information on the labeling of wires and components names. Important: Never attempt to make changes to the boat’s electrical system without the prior approval of the manufacturer!
7. Control The E.motion boat is equipped with an intuitive control knob - joystick mounted in the middle part of the cockpit. The control panel is equipped with an armrest for the convenience. The joystick allows you to control the speed and direction of the boat simultaneously. 7.1 Joystick (speed control) Speed control features eight fixed position of the joystick.
8. Use of the trailer and the special E.motion handcart For transportation, launching and recovery of the E.motion electric pleasure boats you can use trailers for aquatic equipment or a special E.motion handcart with supports, adapted to the contours of the boat. Trailers for aquatic equipment are designed for the transportation of boats by car on the roads of general use.
9. Care and Maintenance 9.1 Charger for batteries For the best results of the electric boat operation, it is recommended to charge the batteries fully before each use. The electric boat is equipped with a built-in charger. To charge the battery you must use a special cable (supplied with built-in charger) for connection to a source of electric power with AC voltage 220 - 230 V, 50 Hz.
9.3 Propeller replacement Before you do anything with the propeller, ensure that the cables to the battery are disconnected. You can remove the propeller simply by loosening and removing the nuts using a special key included in the scope of supply. It is necessary to hold the propeller by hands while loosening the nuts, so that the propeller would not rotate.
10. Storage It is extremely important to clean the boat and maintain it before long (winter) storage. Without doing this, you will significantly increase the cost of maintenance before the next launching, because the combination of salt, moisture and dirt significantly worsens the condition of most components of your boat.
11. Safety precautions Important: The boat is designed for use in small lakes, ponds, rivers and canals where the wind force is no more than 4, the current speed is no more than 3 km/hour, and the wave height is no higher than 0.3 m. Bad weather, strong winds and big waves are the reason of most accidents on the water.
12. Warranty obligations The manufacturer guarantees the quality construction of each boat, according to their tech- nical data sheets, as well as reliable operation within 12 months from the date of purchase, provided that the consumer follows the rules of use, transportation and storage described in this manual.
13. Details on acceptance and sale Electric pleasure boat E.motion, factory No. _________________________ Quality control Date of issue: ___________ ____, 201__ ______________________________ (_________________________________________) (signature) (full name) Company Seal Name and address of trading organization ______________________________________________________________________________ Date of sale: ___________ ____, 201__...