Canor TP106 VR User Manual

CANOR , spol. s r.o., Strojnícka 1, 080 06 Prešov, Slovakia
Tel./Fax: + 421 51 7710 396,
e-mail: canor-audio@canor-audio.com, http://www.canor-audio.com/
CANOR TP106 VR amplifier User Guide
Dear lover of music,
thank you, that you have purchased our CANOR TP106 VR amplifier. To preserve and
maintain the best characteristics of your amplifier, we recommend you carefully read the
following lines.

Safety instructions

Please, read before placing the device in action.
1. Read the instructions - all safety information and instructions should be read before using
the amplifier.
2. Keep instructions - security and user instructions should be stored for possible later use.
3. Follow the instructions - all the security and user instructions should be followed.
4. Water and moisture - amplifier should not be placed near water, for example near the baths,
swimming pool, kitchen sink, etc..
5. Accessories - do not use accessories not recommended by the manufacturer.
6. Location - do not put a device on the fragile backing. The device may fall, which can cause
serious injuries to children or adults, as well as damage to the device. Use only backings or
stands recommended by the manufacturer or sold to dealers at the same time with this device.
Any location of the device should be in accordance with the manufacturer's instructions and
only accessories recommended by the manufacturer should be used.
7. Wall mounting - the device should be mounted on the wall only if the manufacturer
recommends.
8. Ventilation - equipment should be placed so that it guarantees it a good airflow. This means
that it must not lie on the sofa or upholstered furniture, in the working condition it must not be
covered. It would then prevent proper air flow around the vent holes of device.
9. Heat – the device must be located so as to avoid the heating from heat sources, for example
heaters or stoves or other heat-producing equipment. The distance from the rear wall of the
device may not be less than 20 cm, and 30 cm above the area of the amplifier may also be no
obstacle. Alongsides of the unit should be ensured minimum 20 cm distance from other
objects.
10. Power source - the device must be connected only to a power supply, for which it is
proposed.