Operating & Servicing; How To Change The Cartridges - Living Waters TR1 Installation, Instruction And Warranty Manual

Table of Contents

Advertisement

Your   L
W
IVING
ATERS
approximately   ¾   g allon   p er   m inute   f or   a t   l east   1 ,200   g allons.   T his   s hould   b e  
sufficient   t o   p rovide   p urified   w ater   t o   a   f amily   o f   f our   f or   a   y ear.   F ilters   s hould  
be   c hanged   a nnually.   W hen   w ater   f low   s lows   s ignificantly   o ver   a   f ew   w eeks,  
the   f ilters   h ave   b ecome   e xhausted   a nd   m ust   b e   r eplaced.   I f   t his   h appens   m ore  
than   o nce   e very   6   m onths,   y our   l ocal   w ater   c onditions   m ay   r equire   s pecial  
pretreatment   b efore   f iltering.   C all   y our   d ealer   f or   a dvice.  

HOW TO CHANGE THE CARTRIDGES

1.
Always wash your hands thoroughly before and after cleaning your filter.
2.
Make certain that the water is turned off and open tap to relieve pressure in
system. Note: There will still be water in the filter sump(s).
3.
Over the sink, unscrew the sumps from their bases by turning counter-
clockwise. (Use the spanner wrench provided to gently loosen housing then
manually remove.) Replace cartridges one at a time to avoid confusion.
4.
Remove spent cartridge(s) and discard. (Cartridges containing KDF® may be
recycled by returning to your dealer or any firm that recycles scrap metal.)
NOTE: When opening filter housing to change cartridge, it is common for
O-ring gasket to lift out of housing and stick to cap.
5.
Rinse out sump(s) and fill 1/3 with water. Add 2 capfuls of bleach and scrub
thoroughly with brush or sponge. Rinse thoroughly.
6.
Remove   O -­‐ r ing   f rom   g roove   i n   t he   s ump   a nd   w ipe   g roove   a nd   O -­‐ r ing   c lean.    
Re-­‐ l ubricate   O -­‐ r ing   w ith   a   c oating   o f   c lean   s ilicone-­‐ b ased   j elly.     P lace   O -­‐ r ing  
back   i n   t he   g roove   a nd   w ith   t wo   f ingers   w ipe   o r   p ress   i t   d own   i nto   t he  
groove.     N ote:   T his   s tep   i s   i mportant   t o   i nsure   p roper   f ilter   s eal.     M ake   c ertain  
the   O -­‐ r ing   i s   s eated   p roperly   i n   t he   g roove.  
7.
Be   s ure   t o   p lace   t he   n ew   c artridge   i n   t he   s ump   w ith   t he   c orrect   e nd   v isible.    
Hard   p lastic   c artridges   h ave   a n   o pening   i n   o ne   e nd   a nd   t he   o ther   h as   s lots  
around   t he   p erimeter.     I nstall   i nto   t he   s ump   w ith   t he   e nd   v isible   t hat   o nly   h as  
the   o pening   i n   t he   c enter.   I t   s hould   f it   e asily   i nto   t he   s ump.     I f   a ny   p ressure   i s  
required   t o   s lide   c artridge   i nto   s ump,   y ou   a re   i nstalling   t he   c artridge   u pside  
down.     M icrobiological   c artridges   h ave   a   w hite   e nd   t hat   s hould   b e   i nstalled  
toward   t he   t op   o f   t he   s ump.   P leated   c artridges   m ay   b e   i nstalled   w ith   e ither  
end   u p.   O ther   c artridges   m ay   s ay:   " THIS   E ND   N EXT   T O   V ESSEL   T HREADS"   o r  
an   e mbossed   a rrow.   I f   s o,   i nstall   a ccordingly.    
8.
Next,   s crew   t he   c ap   o n   t he   s ump   c lockwise.   H and-­‐ t ighten   o nly.  
L
W
C
IVING
ATERS
 
OUNTERTOP  
OPERATING & SERVICING
™   s ystem   i s   d esigned   t o   p roduce   a   w ater   f low   o f  
Page   1 0   o f   2 0  
S
M
 
YSTEM  
ANUAL

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ct4Ct1Ct2Ct3

Table of Contents