How Do I Setup My Smart Board Once It's Been Installed - TEQ SMART Board Troubleshooting Manual

How do I setup my SMART Board once it's been installed?

First, you will need to connect two cords to your computer. The USB cord (normally a black cord with
a thin, rectangular head — like a flash drive), and either a VGA cord (a 15-pin, trapezoid-shaped head
with 2 screws on the side) or an HDMI cord (a thin, trapezoid-shaped head). Next, confirm you have
the SMART Notebook software installed (if not, see the next question, "How do I download SMART
Notebook?").
The SMART Board status indicator light (located at the bottom right for a 600 series board and on
the pen tray for the 800 series board) should be solid green. Your projector image should mirror your
desktop (if not see "How do I get my SMART Board to mirror my computer screen?"). Follow this link
to Download the SMART Board Quick Reference Guide
Once your computer is on and its image is projected on the SMART Board, it is time to "orient"
the board. Press the keyboard and right-mouse-click buttons located on the pen tray, in front of the
eraser, at the same time to begin the SMART Board orientation. Press the center of each target as it
lights up. Your board is now oriented and ready for use!
teq.com | 877.455.9369
4