Table of Contents
Advertisement
ENGLISH
Flush out the brush by fitting to the handset in place of
the roller holder, before removing from the tube and
washing the bristles under flowing water.
After cleaning allow all parts to become completely
dry. They may then be stored inside the body of your
Paintmate. Never put wet items inside the body.
Do not remove the flexible seal located between the
roller holder and the paint flow guide.
TROUBLE SHOOTING GUIDE
Fault
Possible cause Remedy
Can't open
Orange button
handle.
is down (on)
and unit
pressurised.
Paint leaks
'O' ring
from the
missing from
Handypack.
connector or
contaminated.
Connector not
fitted properly. mating surfaces
Paint leaks
Tube not fitted
from the
correctly.
connector
at the handset.
Paint leaks
'O' ring
from top of
missing or
the handset.
contaminated.
Debris on taper Make sure both
fitting.
Paint leaks
Handypack
from Handypack. damaged.
8
Press orange
button to turn off
and release
pressure.
Check that the 'O'
ring is in place and
is free from
connector debris
(dried paint).
Ensure that the
are free from
debris (dried paint).
Make sure
connector is
pushed in fully and
screwed on (1/4
turn) to a positive
stop.
Firstly switch off.
Undo threaded nut
from handset.
Pull down to
expose connection.
Make sure tube is
pushed on to
connector fully.
Retighten nut.
Check that 'O' ring
is in place and is
is free from debris
(dried paint).
male and female
taper fittings are
free from debris
(dried paint).
Return to retailer.
Fault
Possible cause Remedy
Paint drips
Excessively
from roller.
worn roller.
Paint flow guide Replace paint
damage.
Flexible
connector in
holder is in-
correctly fitted. correctly.
Handset trigger Make sure that you
held on without are painting surface
using roller.
Paint spurts
Air pocket in
from brush
Handypack.
on startup.
No paint
Trigger not
appearing at
depressed.
roller or brush.
Tube kinked.
Handypack
empty.
Pump runs
continuously.
Pump not
operating.
Handset/roller
Not using tap
messy to clean. adapter.
Not kept unit
assembled
during cleaning.
Handset/brush
Trigger not
tube will not
depressed
flush.
during cleaning.
Replace roller.
flow guide.
Make sure the
connector is in
place and fitted
when holding
trigger open.
Prior to connecting
tube to the
Handypack,
squeeze the
Handypack to
expel the air
contained inside.
Make sure you
are holding down
trigger.
Check for kinks in
tube: either
straighten or
replace.
Replace
Handypack.
Air bag damaged
(Contact
authorised
service agent).
Check correct
batteries are fitted
and are charged.
(If no response
contact authorised
service agent.)
Follow cleaning
instructions.
Follow cleaning
instructions.
Follow cleaning
instructions.
Advertisement
Table of Contents
