Troubleshooting Guide - Black & Decker BDP2600 Instruction Manual

PROBLEM
Engine will No fuel.
not start (see
Pressure builds up after two
Engine Manual
pulls on the recoil starter or
for further
after initial use.
engine
Choke lever in the "No Choke"
troubleshoot-
position.
ing)
Spark plug wire not attached.
Engine switch in OFF
po si tion.
Choke lever in the "Choke"
position on a "hot" engine
or an engine that has been
exposed to thermal heat for a
long period of time.
Fuel valve closed.
No or low Spray wand not in high pres-
pressure sure.
(initial use)
Low water supply.
Leak at high pressure hose
fitting.
Nozzle obstructed.
Water filter screen clogged.
No or low Air in hose.
pressure
(initial use)
Choke in the "Choke" position. Move choke to the "No Choke"
High pressure hose is too
long.
TrOUbLE SHOOTING GUIDE
CAUSE
17 - ENG
CORRECTION
Add Fuel.
Squeeze gun trigger to relieve
pres sure.
Move choke to the "Choke"
po si tion.
Attach spark plug wire.
Place engine switch in on posi-
tion.
Move choke to the "No Choke"
po si tion.
Move the fuel valve lever to the
OPEN position.
See How to Use Spray Wand
instructions in the Operation
Section.
Water supply must be at least
5 GPM @ 20 psi.
Repair leak. Apply sealant tape
if necessary.
See Nozzle Cleaning instruc-
tions in the Maintenance sec-
tion.
Remove and clean filter.
Turn off the engine, then the
water source. Disconnect the
water source from the pump
inlet and turn the water source
on to remove all air from the
hose. When there is a steady
stream of water present, turn
water source off. Re- con nect
water source to pump inlet and
turn on water source. Squeeze
trigger to re move re main ing air
po si tion.
Use high pressure hose under
100 feet (30 m).