Table of Contents
Advertisement
Tools Required:
•
Phillips screwdriver
•
5/16" hex wrench
•
slotted screwdriver
•
scissors
1.
Remove two screws that hold fireplace screen in place for ship-
ping. These screws are located near top of screen. Discard
screws. Lift fireplace scree: up and pull out to remove. Set
screen aside until installation
!Hs
been completed.
2.
Cut two plastic straps to remove the log from the firebox cavity.
3.
An optional blower is available. Seedcressonies, pages 38 and
39. Install optional blower now. Follow installation instruc-
tions provided with blower. See page 12 for Remote-Ready
Models or page 14 for Thermostat-Controlled Models.
Firebox Top
Sheet Metal Screws
Figure 4 - Assembling Hood
ASSEMBLY
Assembling Fireplace
N4,MIUMINS.
ASSEMBLY
A
WARNING: Always have branch support and
screen in place before operating fireplace. This pre-
vents excessive temperatures on
fireplace surfaces.
A
WARNING: Failure to position the parts in accor-
dance with these diagrams or failure to use only parts
specifically approved with this fireplace may result in
property damage or personal injury.
ASSEMBLING FIREPLACE
4.
Locate four black phillips sheet metal screws from the hard-
ware packet.
5.
Rotate hood as shown in Figure 4. Make sure hood tabs
point toward fireplace.
6.
Insert hood tabs between baffle and louvers (see Figure 4).
7.
Gently rotate hood to upright position. Make sure hood tabs
are behind louvers and hood is resting on firebox top (see
Figure 4).
8.
Align screw holes on hood with screw holes on firebox top.
9.
Insert screws as shown in Figure 4. Tighten screws firmly.
Figure 3 - Removing Screen
u iiPitz; la! 91.4,114
visit www.desatech.com
•ESA
'07032-01.!
Advertisement
Table of Contents
