Advertisement
Quick Links
C26GO Corner Mantel and Base
ASSEMBLY AND INSTALLATION INSTRUCTIONS
IMPORTANT: Read entire instruction sheet before
assembling or installing mantel kit.
these mantels are only approved for use with any
DesA Heating, llC 26" electric and compact gas
fireplace system. Do not use mantel with any other
product.
This mantel kit contains the following:
• Mantel pieces - unassembled and numbered as follows:
#1 Base
#2 Right Side Assembly
#3 Left Side Assembly
#4 Header
#5 Top
#6 Base Support
#7 Vertical Support
Right Top Trim Strip
Left Top Trim Strip
• Hardware Package
26 - 1
/
" Wood Screws
1
4
8 - 1" Finishing Nails
* Extra hardware may be included
Tools required:
• Power Screwdriver with #2 Phillips Bit
• Hammer
• Nail Set
If any wood pieces are missing or damaged, contact the
dealer where you purchased this mantel for replacement. If
hardware is missing or damaged, contact DESA Heating, LLC
at 1-866-672-6040 for referral information. You can also visit
DESA Heating, LLC's web site at www.desatech.com.
Note: Gather all mantel pieces together before assembling
mantel.
mantel. Damage to mantel will result if other screws
are used for this purpose.
AssemblING mANtel
IMPORTANT: more than one person is required to lift
assembled mantel. lift mantel by leg assemblies. lifting
by header or mantel top could damage mantel.
Use the following illustrations to assemble mantel. Use only
screws provided.
114325-01
114295-04
www.desatech.com
WARNING: Only use 1
/
" screws to assemble
1
4
Advertisement
Related Manuals for Desa C26GO
Summary of Contents for Desa C26GO
-
Page 1: Assembly And Installation Instructions
If assembling or installing mantel kit. hardware is missing or damaged, contact DESA Heating, LLC these mantels are only approved for use with any at 1-866-672-6040 for referral information. You can also visit DesA Heating, llC 26"... - Page 2 Right Leg Assembly #2 " Screws " Screws Left Leg Assembly #3 Base #1 Base #1 Base Support #6 Figure 1 - Installing Base Support Figure 4 - Installing Mantel Base IMPORTANT: Align mantel left to right on base before install- ing. Corner of mantel legs must be flush with back of mantel base before installation (see Figure 5).
-
Page 3: Fireplace Installation
Reinstall floor with screws removed previously. 2. Mantel must be installed flush with two walls. Remove electric Fireplace Installation baseboard along walls where mantel is to be installed. Baseboard will prevent proper installation of mantel and This mantel can be used with DESA Heating, LLC electric base. fireplaces. Electric fireplaces install from the front of mantel. 3. Place mantel base close to installation location. See fire- To install electric fireplace see fireplace instruction manual. place owner’s manual for installation clearances. Leave Vertical support Installation enough room to insert fireplace from back of mantel. -
Page 4: Mantel Installation
Figure 8 - Installing Mantel Trim DESA Heating, LLC 2701 Industrial Drive Bowling Green, KY 42101 www.desatech.com 1-866-672-6040 123674-01 Rev.