Preparations; Mount Bracket Sw458 - Panasonic WV-SW458 Installation Manual

Preparations

When installing the camera on a ceiling or a wall, there are 3 methods as specified below.
• Using a two-gang junction box (
• Installing the camera directly on the ceiling or wall
• Using the supplied mount bracket
IMPORTANT:
• Procure 4 screws (M4) to secure the camera attachment (accessory) or the mount bracket
SW458
(accessory)
not use wood screws and nails.
For mounting a camera on a concrete ceiling, use an anchor bolt (M4) or an AY plug bolt (M4)
for securing. (Recommended tightening torque M4: 1.6 N·m {1.18 lbf·ft})
• Mount the camera attachment (accessory) in consideration of the camera angle in accordance
with the instructions (
• Required pull-out capacity of a single screw/bolt is 196 N {44 lbf} or more.
• If a ceiling board such as plaster board is too weak to support the total weight, the area shall
be sufficiently reinforced.
The mounting conditions of the camera are described as follows:
Installation Appropriate mount
place bracket
Ceiling/wall Two-gang junction box
SW458M
(Direct mounting)
Ceiling/wall
SW458 Mount bracket (accessory) M4
Ceiling/wall*
* The conditions for securing the mount bracket to a ceiling or a wall are described here.
☞
pages 18 and 19)
SW458
to a ceiling or a wall according to the material of the installation area. Do
☞
pages 18 to 23).
Recommended
screw
M4
M4
☞
SW458M
( page 19)
☞
( pages 20 to 23)
Number of
screw
4 pcs.
4 pcs.
4 pcs.
Minimum pull-out
strength (per 1 pc.)
196 N {44 lbf}
196 N {44 lbf}
196 N {44 lbf}
17